Introduction
The HTC Vive's focus knob may wear down or crack with use. This guide will show you how to replace the Vive's focus knob.
-
-
Slide the HTC panel covering the cables forward, away from the Vive.
-
Gently pull on each of the four connectors to remove the sound and Three-in-One cables.
-
-
-
Undo the hook and loop tape on the straps.
-
Slide the ends of the straps through the hinge loops.
-
-
-
Use a T6 Torx Screwdriver to remove either of the two 12mm hinge screws holding the two hinges in place.
-
Allow the hinge to fall away once the screw is removed.
-
Repeat for the opposite side.
-
-
-
Orient the Vive so that the camera is facing towards you and the connector ports are facing upwards.
-
There are four screws you need to remove that are covered with small black stickers (two on top, two on bottom).
-
Use a plastic opening tool to gently pry up the left side of the outer sheath.
-
Slide the left side of the sheath outwards.
-
-
-
Slide a plastic opening tool underneath the right side of the sheath to remove any remaining glue.
-
Using the plastic opening tool, pry the right side of the sheath upwards slightly.
-
Using your hands, slide the right side of the sheath outwards.
-
-
-
Remove the focus knob by unscrewing one 4mm #00 Philips head screw.
-
Pull the knob outwards from the device.
-
To reassemble your device, follow these instructions in reverse order.
