HP Pavilion 14-v062us Keyboard Replacement

Written By: Flora Peterson
  • Comments: 2
HP Pavilion 14-v062us Keyboard Replacement

Difficulty

Moderate

Steps

9

Time Required

15 minutes

Introduction

HP Pavilion 14-v062us Keyboard

If your HP Pavilion 14-b120dx laptop has sticky keys, missing components, or an overall malfunctioning keyboard, it might be time to replace the keyboard. This operation isn’t as hard as one may think. In fact, with the right materials, you can tackle this job in just a few steps.

For precise instructions, use this guide to replace the keyboard. This guide will show you how to replace the keyboard on your HP Pavilion 14-v062us. Before starting, make sure your device is turned off and disconnected from any power sources. Transfer your laptop to a stable, dry, working surface to begin the operation. The installation process is just the reverse order of the removal process.

  1. cZWJU1c2J6oZODjP
    cZWJU1c2J6oZODjP
    uZKWGBRBGQ6cdtnG

    • Power laptop off and make sure it is not plugged into charger

    • Push inward towards the center of laptop (it may take a lot of pressure). Battery should release once buttons are completely pushed in

  2. DxT1byvNLOSq1Wxg
    DxT1byvNLOSq1Wxg
    6CEP54IKnCmFcQRN

    • Lift the battery upwards and out from the laptop

  3. 2XhDvbems1F4imDl
    2XhDvbems1F4imDl
    1Lgivl53HBs3i3Mh
    DNGBWynt6amENEHA

    • Remove rectangular rubber tops with a spudger

    • Remove the two 4.60 mm PH#1 screws located under rectangular rubber tops.

    • Remove plastic edge covering with the blue plastic opening tool.

    • Remove two 4.63 mm PH#1 screws located under plastic edge covering.

  4. Xb4GphiAiHM1GgD5
    Xb4GphiAiHM1GgD5
    wsAOGXd6v2IOwp1I

    • Use Phillips screwdriver #1

    • Remove all nine 7.09 mm PH#1 screw black screws including small rectangular cover.

    • Remove the three 7.14 mm PH#1 screws.

    • Remove the one 7.09 mm PH#1 screw that will be underneath the small rectangular cover

  5. OxTGJlVkwCWu2qP1
    OxTGJlVkwCWu2qP1
    TssviiWkJCL6ELaS

    • Remove disc tray

    • Locate screw within computer that is inside of where the disc tray was

    • Using a Phillips #1 screwdriver, unscrew the screw

    • Set laptop down and open laptop so the keyboard is facing you

  6. qhG4ooLlaDwQJDOt
    qhG4ooLlaDwQJDOt
    QCVQBj1KtnJvwuNB
    RbrRwRM6O5rtPlkH

    • Using a spudger or plastic opening tool, pry along siding of keyboard, where it connects to the rest of the laptop

    • Pry until you are able to lift entire face and keyboard

    • Only cables should be connecting it underneath

  7. yCEPI2XNnSSv3Bsu
    yCEPI2XNnSSv3Bsu
    gJFEVxmrTBAZfoos
    ITSYlrtCLYTBGeT3

    • Disconnect/ unplug cables using plastic opening tool.

    • Separate the keyboard panel from the laptop with your hands.

    • Turn around the laptop and lay it flat.

  8. QYorHK3taUkVPuO1
    QYorHK3taUkVPuO1
    hMRhIqPLPS6Ks4R1

    • Use a spudger to pry around the first layer of the silver panel until you are able to remove it

    • Only use a metal spudger as a last resort

  9. 13psWpACJSIQBDeS
    13psWpACJSIQBDeS
    4WxdWaKKrrns6dKo
    pHBW1ksUFJUyjPT5

    • Using a spudger tool, start prying around the second layer of the silver panel until you are able to remove it

    • Only use a metal spudger as a last resort

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Flora Peterson

Member since: 21/09/17

233 Reputation

2 comments

Thank you so much, this guide is very helpful.

Rodolfo Trujillo -

Thank you for the guide. It was very helpful!

dmitryp80 -