Google Pixel 9 Pro XL Rear Cover Replacement

Written By: Spencer Day

Comments: 0

Google Pixel 9 Pro XL Rear Cover Replacement

Difficulty

Moderate

Steps

Time Required

45 minutes - 1 hour

Introduction

This repair guide was authored by the iFixit staff and hasn’t been endorsed by Google. Learn more about our repair guides here.

Follow this guide to replace a broken or cracked rear cover on your Google Pixel 9 Pro XL.

You'll need replacement rear cover adhesive to complete this repair.

Note: Any repair can compromise the water resistance of your phone. Retaining water resistance after the repair will depend on how well you reapply the rear cover adhesive.

Tools

Parts

Step 1

Let your Pixel's battery drain below 25% before starting this repair. A charged lithium‑ion battery may catch fire if damaged.
Unplug all cables and completely power down your phone.

Step 2

Adhesive secures the perimeter of the rear cover to the frame.
When separating the adhesive, don't insert your tool more than 3 mm under the rear cover to avoid damaging the internal components.
Measure 3 mm from the tip and mark your opening pick with a permanent marker. Alternatively, you can tape a coin to a pick 3 mm from the tip.

Step 3

Attach a suction handle to the bottom edge of the rear cover, as close to the edge as possible.

Step 4

Pull up on the suction handle with strong, steady force to create a small gap under the rear cover.
Insert the tip of an opening pick in the gap.

Step 5

Slide your opening along the bottom edge to separate the adhesive securing it.
Remember: don't insert the opening pick deeper than 3 mm.

Step 6

Slide your opening pick up the left edge and along the top edge to separate the adhesive.

Step 7

Slide your pick down the right edge to separate the remaining adhesive.

Step 8

Don't try to fully remove the rear cover yet, as a ribbon cable on the right edge connects it to the phone.
Use the suction handle to lift the left edge of the rear cover and swing it over the right edge, like opening the cover of a book.
If you're having trouble, check the perimeter for any remaining adhesive and use your opening pick to separate it.
Prop up the rear cover with the suction handle so you can access the ribbon cable near the top right corner.