Introduction
This guide goes over how to replace the vibration motor on a GameSirT4 Pro controller. If the motors are not vibrating, vibrating too violently, or other issues are happening, this guide covers the proper removal and reinstallation of the vibration motors.
-
-
Remove the following screws on the back case using a Phillips screwdriver:
-
Two 9.2 mm
-
Two 11.3 mm
-
Insert an opening tool in the seam between the front and back case.
-
Pry around the perimeter until the back case releases.
-
-
-
Use tweezers to pull the right vibration motor connector directly out of its motherboard port.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
