GameSir G7 SE Motherboard Replacement

Written By: Colton Kerrick
  • Comments: 1
GameSir G7 SE Motherboard Replacement

Difficulty

Easy

Steps

5

Time Required

No estimate

Introduction

The GameSir G7 SE motherboard replacement guide is intended for users facing complex operational issues stemming from the device's central circuit board. Such problems could range from power issues to unresponsive controls.

Prior to beginning this repair, disconnect the controller from all power sources and prepare ESD-safe tools to prevent damage to electronic components. Due to the complexity of this task, it’s important to follow each step meticulously to avoid further issues.

  1. gMT2OWRFEieAKaIw

    • Remove the faceplate by prying upwards with a plastic opening tool.

    • This faceplate is magnetic and will be easy to come off.

  2. iPFL14icDv16tSww
    iPFL14icDv16tSww
    JjwaTPMDqA4nXZUT

    • Use a T6 Torx Screwdriver to remove the six 9 mm screws from the interior face plate.

  3. LFnmCOeCIKxX1CxM
    LFnmCOeCIKxX1CxM
    xP6LnxPraYmECDmQ

    • Using a plastic spudger tool, remove the interior face plate. Go around all the edges, prying downwards until it's removed.

    • Make sure to hold the controller upside down; otherwise the buttons will fall out.

  4. lirQSiHLMRsh41HD

    • Use the Phillips #0 screwdriver bit to remove the four 9 mm screws holding the motherboard in place.

  5. lNr2uegAxE2pmgD5

    • Pull straight up on the board to remove the motherboard and connecting components

    • Be careful to not dislodge the back buttons from the back plate housing

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Colton Kerrick

Member since: 18/01/24

85 Reputation

One comment

Hello,where did you find or buy a new motherboard for this?

DavidofSlim7 -