Introduction
If your monitor and display is working, but your camera wont turn on then here is a guide on how to replace it. The only tools you will need is a #1 Philips head screwdriver and a #00 Phillips head screwdriver if needed.
-
-
Take the two tabs off the sides of the camera by unscrewing the four 1.2 mm Phillips #1 screws connected.
-
-
-
When the screws are out, pop the two tabs off the sides.
-
Then you can pull off the back panel. You will then be left with the camera and wires. To install the new camera simply retrace these steps.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
