EasySMX ESM-9110 Vibration Motor Replacement

Written By: Melanie Rodriguez
  • Comments: 0
EasySMX ESM-9110 Vibration Motor Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 10 minutes

Introduction

This guide is a detailed process on how to remove the vibration motors on the EasySMX ESM-9110 gaming controller. The EasySMX ESM-9110 controller contains two vibration motors which operate during gameplay. The replacement of these vibration motors will most likely fix any issues being had.

  1. w11ERDQZOBQFg6Nm
    w11ERDQZOBQFg6Nm
    UvIfIvxDUBcZDWwE

    • Use a Phillips #000 screwdriver to remove the two 10 mm screws from the back of controller.

  2. M1MhWsvQ44CAlKrA

    • Insert a plastic opening tool into the slit on the side of controller.

    • Wiggle the tool until the cover becomes loose.

    • Repeat this on the other side of Controller.

    • Go slow. Take your time removing the handle covers.

  3. TpIDmw2eiQOIMtRP

    • Remove the faceplate.

    • Repeat on the other side of the controller.

  4. hZeIrZEKLRIwrpm6
    hZeIrZEKLRIwrpm6
    ECglXmCmGbZCJcBO
    POTOAVTDWYVuXAbj

    • Use a Phillips #000 screwdriver to remove the four 20 mm screws from the controller's faceplate.

    • Use a Phillips #000 screwdriver (a screwdriver bit extension may be needed) to remove the two 20 mm screws from the controllers faceplate.

    • The screw extender should only be used to unscrew two of the six screws. Do not use it for all six.

  5. ZgF1FS3bVGCY3sbk
    ZgF1FS3bVGCY3sbk
    qYBaqb2bKOuTAmSV

    • Remove the faceplate of the controller by lifting it directly up from the backplate.

    • Be gentle, the controller's backplate is still attached. Do not move the controller too roughly.

  6. WBX4CaYUw1ICyoag
    WBX4CaYUw1ICyoag
    CWabIGR2P5tRiy2y

    • Locate the parts of the vibration motor that are connected to the motherboard

    • Solder these parts of the vibration motor to remove them.

    • There should be two connectors present in your controller, one for each vibration motor.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Melanie Rodriguez

Member since: 18/03/24

385 Reputation

0 comments