EasySMX ESM-9110 Handle Cover Replacement

Written By: Melanie Rodriguez
  • Comments: 0
EasySMX ESM-9110 Handle Cover Replacement

Difficulty

Easy

Steps

3

Time Required

3 - 5 minutes

Introduction

This guide will teach you how to remove the handle covers from your EasySMX ESM-9110 controller. Initially, screws will be visible on the back of the controller.

  1. w11ERDQZOBQFg6Nm
    w11ERDQZOBQFg6Nm
    UvIfIvxDUBcZDWwE

    • Use a Phillips #000 screwdriver to remove the two 10 mm screws from the back of controller.

  2. M1MhWsvQ44CAlKrA

    • Insert a plastic opening tool into the slit on the side of controller.

    • Wiggle the tool until the cover becomes loose.

    • Repeat this on the other side of Controller.

    • Go slow. Take your time removing the handle covers.

  3. TpIDmw2eiQOIMtRP

    • Remove the faceplate.

    • Repeat on the other side of the controller.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Melanie Rodriguez

Member since: 18/03/24

385 Reputation

0 comments