Introduction
Today the scales did not go anymore.
The display remained black.
So I had to find a way to disassemble.
Extra rausholen the Heißluftföhn and time consuming to heat the glass plate? It would have to be easier!
Tools
-
-
Since it is not important in the balance to get the adhesive surfaces take a beveled spatula. It's much easier and faster.
-
-
-
Contrary to the other instructions, the board is located directly on the plastic housing. Through the 3 holes water gets into the balance and through the adhesion it spreads over the complete underside of the board
-
The Libra continues to change. Only this time too much water had penetrated which had spread under the board.
-
Clean the underside of the board with acetone. Alternatively, isopropanol.
-
After the board was dry, the scales spoke to me again. And so that water does not penetrate again, I taped the holes with silicone
-
Finally, glue the round cap to the glass plate with a little silicone glue. Because even if the board has a silicone protective coating, it would not be good if Wassser came from above on the SMD components.
-
Repeat the steps in order to reassemble your device.
3 comments
this does not tell you how to open it, only to use a spatula. this is not a guide, it is a waste of time.