Dyson Supersonic HD01 Filter Mesh Replacement

Written By: Ezra Linza
  • Comments: 4
Dyson Supersonic HD01 Filter Mesh Replacement

Difficulty

Moderate

Steps

4

Time Required

5 - 15 minutes

Introduction

This guide details how to replace a broken filter on a Dyson Supersonic HD01 hair dryer. The filter is most likely to be the first issue encountered after prolonged use of your hairdryer. Filters may become broken from overuse or accidental incidents. After this guide, your Dyson HD01 will have a complete new and fixed filter.

  1. XRwwjuHKrrPGW4gF
    XRwwjuHKrrPGW4gF
    qVUg2PHqmMZsSLIR

    • Find the red dot along the top of the filter cover.

    • The red dot will be aligned with the white dot at the bottom of the hair dryer's handle.

    • Twist the filter cover counter-clockwise until the red dot is shifted to align with the white empty circle on the dryer handle.

  2. wMAXTGKRbkvKcfnm
    wMAXTGKRbkvKcfnm
    pADghCfBSomUrEfl

    • Remove the filter cover by sliding it off of the handle.

  3. f1AEDj5oP5iyGqyE

    • Remove the two retaining screws at the base of the handle using a T6 Screwdriver.

  4. xPX1AXfyb1gyJJDK
    xPX1AXfyb1gyJJDK
    Jmh2JwG63mKgVlbb
    vv6qrvyFY6JPZckC

    • Seperate the filter mesh at the plastic seam by pulling it apart.

    • Remove the filter mesh by sliding it off of the handle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ezra Linza

Member since: 28/09/22

151 Reputation

4 comments

This guide is misleading and obviously trolling. The cable is attached to two ton of power converter bricks there's no way this thing will "slide off" the cable. lol.

gcb -

The REAL procedure is so complicated, the only REAL tutorial/guide i have found prefers to disassemble the entire device instead of dealing with the power bricks. https://www.youtube.com/watch?v=2XnUlUBZ...

gcb -

slide right off. lol. https://www.youtube.com/watch?v=fsiXJndd... hope you have a saw and several pry tools.

gcb -

updated the guide but i'm not sure how to add steps from another guide (on replacing the motor) up to step 6 only...

gcb -