Dyson Supersonic HD01 Filter Cover Replacement

Written By: Sebastian
  • Comments: 0
Dyson Supersonic HD01 Filter Cover Replacement

Difficulty

Moderate

Steps

2

Time Required

2 - 10 minutes

Introduction

If you've found yourself in a situation where the plastic air filter cover of your Dyson Supersonic HD01 has been damaged due to a drop or impact, fear not! This guide is here to help you replace the cover and get your hairdryer back in working order.

  1. vwcgHLXeToqJwEHg
    vwcgHLXeToqJwEHg
    Fjcc2bliiQl1OMqP

    • Find the red dot along the top of the filter cover.

    • The red dot will be aligned with the white dot at the bottom of the hair dryer's handle.

    • Twist the filter cover counter-clockwise until the red dot is shifted to align with the white empty circle on the dryer handle.

  2. nqvTMSOXJZOLGOxO
    nqvTMSOXJZOLGOxO
    fkXPQCZqXh65oEmL

    • Remove the filter cover by sliding it off of the body of the hairdryer.

    • Use a saw or sidecutters to destructively remove the broken filter cover from the cable while taking care to not damage the insulation of the power cable.

    • The replacement part will have a slot on the side that makes it possible to install it by sliding onto the cable.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sebastian

Member since: 19/08/18

27348 Reputation

0 comments