Cuisinart DGB-650 Motherboard Replacement

Written By: jake hardison
  • Comments: 0
Cuisinart DGB-650 Motherboard Replacement

Difficulty

Moderate

Steps

6

Time Required

55 minutes

Introduction

If the electronic panel on your Cuisinart DGB-650 is not turning on or working, you will need to replace the motherboard. Make sure everything is unplugged to ensure that you do not encounter any shocking.

  1. NDSLj5bnFxub2cdF
    NDSLj5bnFxub2cdF
    efrjty2jZCmPKDdZ
    VL6aSIqputpou5Yv

    • Turn the coffee maker upside down.

    • Remove the four 1.2 mm screws using a Phillips #0 screwdriver.

    • Remove the bottom cover to expose the heating element and pipes.

  2. XCYUMsf624RNVCbe
    XCYUMsf624RNVCbe
    qVG1XOgaC6PvDJXT
    DHSHdUSl3ZZqnYCD

    • Firmly grasp both pipe endings next to the motherboard and gently pull both ends out.

  3. IZCGfleHPFrGtFi1
    IZCGfleHPFrGtFi1
    EBgamRFsMmGVQY11
    JBgLAyETQBgWTDjm

    • Remove the two 1.2 mm screws keeping the pipe clamp attached using a Phillips #0 screwdriver.

    • Lift the pipe clamp up and set it aside.

  4. ZyUZunBjH2dIGMNr
    ZyUZunBjH2dIGMNr
    mXciJ6XLGjLHmN3R
    lwqsqLpLCCc1QSlx

    • Remove the four 1.2 mm screws using a Phillips #0 screwdriver.

    • Remove the lid to get access to the motherboard.

  5. Y4cDJOuEJWqH2ubH
    Y4cDJOuEJWqH2ubH
    fJP1SXJVK3nJ64gl

    • Gently grasp and remove the expansion slot on the motherboard with the six colorful wires intertwined together.

    • Gently grasp and remove the expansion slot.

  6. 4TxlTm3eKpdgSVSU
    4TxlTm3eKpdgSVSU
    mgQIDkmfpccBUYVO
    kdDCqR63TlhWRbO5

    • Use pliers to remove the plastic clamps from each of the six wires connected to the motherboard.

    • The motherboard should now be completely separated from the coffee maker.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

jake hardison

Member since: 01/10/24

220 Reputation

0 comments