Coby DVD209 4-Pin Ribbon Cable Replacement

Written By: Yufay Chow
  • Comments: 0
Coby DVD209 4-Pin Ribbon Cable Replacement

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

  1. Mep5sCPurCGvLAxo
    Mep5sCPurCGvLAxo
    w2eMOT6pFgYbwcQ2
    mRXrooqlb3ZYNXQU

    • Press the eject button to view the laser inside.

    • Using the blue plastic tool and the tweezers, remove the ribbon cable.

  2. r2WOeFJJHJp1nxYA
    r2WOeFJJHJp1nxYA
    jYvFoQDNUFPwjyR5
    uIQIpUHMSni3d2kf

    • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

    • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

    • Pry the top of the device open from the right side where the buttons are located.

  3. VhUZUXCvDsi1R3AF
    VhUZUXCvDsi1R3AF
    a6iYqnmpgALnVQLl
    SSXOcsroJ1LNpon4

    • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

    • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

  4. WAkOfZWSaLPYroTA
    WAkOfZWSaLPYroTA
    USQEeSxJH1B1fBT6
    GX2nQWtt2KeCmMrv

    • Position the DVD player so that the power and AVI ports are facing you.

    • Pull the white cable with the blue adapters off of the circuit boards.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Yufay Chow

Member since: 23/01/12

92 Reputation

0 comments