Classic Ripstik Caster Board Wheels Replacement

Written By: JairoSantos
  • Comments: 0
Classic Ripstik Caster Board Wheels Replacement

Difficulty

Easy

Steps

7

Time Required

5 - 10 minutes

Introduction

When you have been riding a RipStik (also known as RipStik Classic Caster Board (15055040) by Razor) for a long time or need a new change in style, changing your wheels is vital for the safety of your ride. I will show you how to switch out old wheels for brand-new ones and give your ride a fresh new feel. It takes little skill to complete this task. All it takes is around 8 minutes and minimal hardware work to ensure the safety of your next RipStik ride.

  1. jhoFlEgiNDIc2tfo
    jhoFlEgiNDIc2tfo
    GCXKMFaeFW2VF1kN
    xFkZPUaNGCmjwxdX

    • Use 2 5mm Allen Wrenches on both sides of the wheels and rotate both wrenches counterclockwise to take out the wheel, axle bolt, screw bolt, and 2 washers.

  2. GMoctrrwkBLdvxpx
    GMoctrrwkBLdvxpx
    tctXOFMx4bFlU4yu
    XaMVQl6ZVjVDTTkI

    • Take off the screw bolt on one end and the axle bolt on the other end.

    • Once you disassemble, make sure to save the bolts and washers in a safe place. You will use them for the new wheels.

  3. bhNZnbtbnsjOJCOX
    bhNZnbtbnsjOJCOX
    CIvdP2MMsOKUo4LT

    • Slide the axle bolt through the hole on the outside and place the washer on the inside.

  4. KmQKoXEnV5ESAb3x
    KmQKoXEnV5ESAb3x
    hwBytrftESuSgsyQ

    • Slide the axle bolt out just enough to place the wheel in the middle.

    • Slide the axle bolt through the middle of the wheel to hold the wheel in place.

    • It is easier to slide the bolt through the wheel if the wheel is being placed sideways.

  5. AfO6y6twGVyTluvR
    AfO6y6twGVyTluvR
    WIp1OHlrCoihRbQr

    • Place the second washer in between the wheel and the caster wall.

  6. MyokOhXcCicDP4Ox
    MyokOhXcCicDP4Ox
    n2vJUSpT5rRrLRZN

    • Insert the screw bolt through the outside of the caster wall to go through the washer and the wheel.

  7. qrp3lYApCDlBWuMf
    qrp3lYApCDlBWuMf
    W4GWchO5HVwMNwWw
    wmMXd5bFgHFfDvTE

    • Much like step 1, use 2 allen wrenches to screw in the wheel and secure it in place.

    • When screwing it, it is easier to hold one hand firm while rotating the other wrench clockwise to tighten.

Conclusion

To replace your old RipStik wheels with brand new ones. Simply follow these steps and enjoy a brand-new ride!

Author

JairoSantos

Member since: 04/04/23

195 Reputation

0 comments