Changing the thermostatic cartridge - Thermostatic Bath NF SIRYO CHROME

Written By: iRobot
  • Comments: 0
Changing the thermostatic cartridge - Thermostatic Bath NF SIRYO CHROME

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

  1. gTnYEBSjvxo6kVdB

    • 24mm wrench

    • 21mm wrench

    • Flathead screwdriver

    • Phillips screwdriver

  2. gSBAQFmvRGXpTFSI
    gSBAQFmvRGXpTFSI
    YJ6BxTKYDRealglB
    LxparDL263LIBkNc

    • ATTENTION: Before any disassembly of the inverter, remember to close the water supply from the meter.

    • Check that the position of the reverse handle is on 'OFF'

    • Using a small flat screwdriver, unclip the access cover to the screw that holds it in place.

    • Using a Phillips screwdriver, unscrew the fixing screw of the handle.

  3. TkgTjweGSDWN5BDg
    TkgTjweGSDWN5BDg
    RhPWvHtYLDPPsVHY

    • Unscrew the handle.

  4. V6xEGLfKPrTCZCBJ
    V6xEGLfKPrTCZCBJ
    MBEMuANQAhKSqB1G

    • Using a 24 flat wrench, unscrew the nut counterclockwise.

    • Remove the inverter.

  5. Rb65ygwWEEv4CuLI
    Rb65ygwWEEv4CuLI
    HPWx2OLDLtNYYBwS
    QYqnQMgePWIDkLdn

    • Replacing the inverter

    • Please make sure to properly align the pin of the diverter with the notch indicated by the arrow in the body of the faucet.

  6. LuujabYxJIXCxro1
    LuujabYxJIXCxro1
    kIecCdWRcHGhV6Tp
    nTExgUnrV1fBPHhY

    • Insert the diverter into the body of the faucet.

    • Hand-tighten the inverter mounting nut clockwise.

    • Finish tightening using the 24mm wrench.

  7. AXMUkZxVaNJmLrDN
    AXMUkZxVaNJmLrDN
    JWJLTMCPMyVH2D5P
    UtCx5diDPMDJIyKM

    • Align the reference point of the faucet body with the "OFF" marking on the handle.

    • Tighten the fixing screw of the handle using a Phillips screwdriver in a clockwise direction.

    • Put the cover back in place.

Author

iRobot

Member since: 25/09/09

0 Reputation

0 comments