Introduction
Use this guide to replace the filter for an American Plumber Water Filter housing model # WC34-PR.
The filter sifts out sediment from the water source entering your house. These particles can harm appliances in your home, and damage water pipes.
Replace the American Plumber Water Filter every 4 months. Replace the filter earlier if there is sediment in the house water or the filter looks dirty.
Tools
Parts
-
-
Turn on a faucet inside the house to drain the water out of the pipes.
-
Leave the faucet on until no more water comes out.
-
-
-
Press the button on top of the device for approximately 10-15 seconds until all of the water is drained.
-
-
-
Hold the top of the device and the pipes steady and rotate the clear part of the filter to the left to remove it.
-
Loop the strap around the filter and place the remaining strap into the slot in the wrench.
-
Ensure the handle of the wrench is close to the filter container and that there is no slack in the strap.
-
Grip the handle firmly to hold the strap in place.
-
Twist to the left to unscrew the filter housing.
-
-
-
Inspect the gasket to see if it has visible damage or dirt.
-
Clean any dirt off the rubber ring.
-
If the rubber ring is damaged, replace it with a new gasket.
-
