1999-2001 Mazda Miata (MX-5) Door Speaker Replacement

Written By: Nathan J
  • Comments: 0
1999-2001 Mazda Miata (MX-5) Door Speaker Replacement

Difficulty

Moderate

Steps

7

Time Required

10 - 20 minutes

Introduction

As Miatas get older, some parts start to wear out. This includes the car's audio system. If your audio makes a rattling or vibrating sound, it may be time to replace the speakers.

This guide will show how to remove the door speaker on a 1999-2001 Mazda Miata, so that it can be replaced or upgraded.

Step 1 is optional but is generally good practice when working with the electrical system.

Before starting, it is recommended that you get replacement retainer clips. They break easily. Be sure to power down the ignition, place the car in park, and engage the parking brake.

  1. pEqjF2RvpRLT1ldn
    pEqjF2RvpRLT1ldn
    FTmQGCfdjNvXR4sc

    • The battery is in the right side of the rear cargo compartment. It can be found by moving the carpet and wood cover.

    • With a 10mm wrench, remove the positive battery terminal.

    • Do not let any metal in contact with the positive battery terminal contact any other metal item. This might make sparks.

  2. GKHRXe3lCqnJc1j1
    GKHRXe3lCqnJc1j1
    BjRyvCkwxnLVU5oS
    fSQPeTWlZGcXjNHB

    • Remove the three trim panel retainer clips.

    • Old clips might break easily. Be extra careful when removing them or get spares.

  3. BIU2dFcikPrmLR5S
    BIU2dFcikPrmLR5S
    MFHGJpBpoLoBvtSQ
    oL1HqPsyBbJLSmxM

    • Remove the three screws that hold the door panel in place.

    • These screws are all different, so keep note of where they all go. The short screw goes in the door latch; the long screws go in the door handle.

  4. 65uWeIxAOfytabSy
    65uWeIxAOfytabSy
    tIPZ6pfhYglQopNg

    • Remove the cover around the door latch by pulling the handle and rotating the cover.

  5. CODslLQumSaU6iHG
    CODslLQumSaU6iHG
    DQnQZaUVP3CLgEFH

    • Remove the door panel by pulling the bottom out and lifting up.

  6. DY6yHePBi51J2ug5
    DY6yHePBi51J2ug5
    6WfFwyivYpRZ5Ifc
    VMOVmDsZu1DSoAGj

    • Remove the four screws holding the plastic speaker mount.

    • As you remove the screws, don't let the speaker fall out and pull the wire.

  7. YcLkvnBDOCLEgMD1
    YcLkvnBDOCLEgMD1
    sWTXgARsE2q3VsbA
    KOOqNmHWLlBpMI3U

    • Detach the connector that powers the speaker by pressing down on the top latch and gently pulling.

    • A small screwdriver might help with the latch but be careful. Old plastic can be brittle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nathan J

Member since: 20/02/24

145 Reputation

0 comments